Volkswagen Golf Service & Repair Manual: Removing and installing bonnet lock, RHD vehicle
|
|
|
| – | Open bonnet. |
| – | Remove Bowden cable on mounting bracket → Chapter |
| – | Disconnect connector for bonnet contact switch. |
Note| The connector is secured next to the right headlight. |
| – | Remove bolts -3- from lock carrier and remove bonnet lock -1- upwards -arrow a-. |
| – | Unclip retainer -5- from bonnet lock. |
| – | Slightly remove retainer -5- from bonnet lock -1--arrow b- and unhook cable -4--arrow c-. |
| – | Remove microswitch -6- from bonnet lock. |
|
| – | Hook in cable -5--arrow a- and clip retainer -4- into bonnet lock -1--arrow b-. |
| – | Install microswitch -6- in bonnet lock -arrow c-. |
| – | Insert bonnet lock -1- into lock carrier -arrow d-. |
| – | Screw in bolts -3-. |
| – | Connect connector for bonnet contact switch -6-. |
| – | Install Bowden cable on mounting bracket → Chapter. |
| – | Adjust bonnet lock → Chapter. |
| – | Before closing bonnet, check function of release lever and cable. |
| Specified torques |
| Bonnet lock → Chapter „Assembly overview - Bowden cable“ |
Removing and installing bonnet lock, LHD vehicle
Special tools and workshop equipment
required
Removing
Torque wre ...
Removing and installing bonnet release lever
Removing
–
Tighten release lever -1- and unlock
bonnet.
–
Insert a small screwdrive ...
Other materials:
Removing automatic distance control unit from and installing on retaining
plate, variant 2
Special tools and workshop equipment
required
Calliper square -VAS 6335-
Removing
–
Remove adaptive cruise control unit -J428-
→ Chapter.
& ...
Removing and installing engine speed sender -G28-
Special tools and workshop equipment
required
Socket AF 4 mm -T10370-
Removing
–
Remove noise insulation
→ General body repair ...
Assembly overview - poly V-belt drive, vehicles without air conditioner
compressor
1 -
Bolt
Renew
150 Nm +180°
Use counterhold -T10475- to loosen and tighten.
Risk of damage to engine caused by incorrect valve timing.Do not turn crankshaft
out of TDC position.
2 -
...
