VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing bonnet lock, LHD vehicle

Special tools and workshop equipment required
   
Removing
 

Torque wrench -V.A.G 1331-
Torque wrench -V.A.G 1331-

Removing and installing bonnet lock, LHD vehicle

–  Open bonnet.
–  Remove Bowden cable on mounting bracket → Chapter
–  Disconnect connector for bonnet contact switch.
  Note
The connector is secured next to the right headlight.
–  Remove bolts -3- from lock carrier and remove bonnet lock -1- upwards -arrow a-.
–  Unclip retainer -5- from bonnet lock.
–  Slightly remove retainer -5- from bonnet lock -1--arrow b- and unhook cable -4--arrow c-.
–  Remove microswitch -6- from bonnet lock.

Installing

Removing and installing bonnet lock, LHD vehicle

–  Hook in cable -4--arrow a- and clip retainer -3- into bonnet lock -1--arrow b-.
–  Install microswitch -6- in bonnet lock.
–  Insert bonnet lock -1- into lock carrier -arrow c-.
–  Screw in bolts -3-.
–  Connect connector for bonnet contact switch -6-.
–  Install Bowden cable on mounting bracket → Chapter.
–  Adjust bonnet lock → Chapter.
–  Before closing bonnet, check function of release lever and cable.
Specified torques
  Bonnet lock → Chapter „Assembly overview - Bowden cable“
Adjusting bonnet
Adjusting bonnet Special tools and workshop equipment required         ...

Removing and installing bonnet lock, RHD vehicle
Special tools and workshop equipment required         Torque wrench -V.A.G 1331- ...

Other materials:

Removing and installing tyre pressure sensor, metal valve body
Special tools and workshop equipment required     Torque wrench -V.A.G 1410- and 11 mm insert tool-V.A.G 1331-. –  Push metal valve with rubber seal t ...

Safety precautions during road tests in which test and measuring equipment is used
Safety precautions during road tests in which test and measuring equipment is used Risk of injury due to unsecured test and measuring equipment If a front passenger airbag is triggered during an accident, unsecured test and measuring equipment can become dang ...

Removing and installing Hall sender 3 -G300-
Removing     –  Release hose clips -1- and -2-, and remove air pipe.   –  Disconnect electrical connector -1-. ...

© 2016-2024 Copyright www.vwgolf.org