VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing bench seat / individual seats

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Seat frames / Rear seats / Removing and installing bench seat / individual seats

Removing
–  Move front seats as far forwards as possible.
–  Unclip guides -1- for ISOFIX child seat anchor (qty. 4) from anchors → Chapter.
 

Removing and installing bench seat / individual seats

–  Grasp with one hand on one side under frame of rear bench seat.
–  Using both hands, pull rear bench seat -1- upwards with a firm jerk -arrows A-. This will disengage wire hook -2- of rear bench seat from mounting grommet -3-.
–  Repeat the procedure on the other side of the rear bench seat -arrows B-.
 

Removing and installing bench seat / individual seats

–  Slightly lift up rear bench seat -1- at front and push wire frame -2- towards rear out of arresters -3-.
–  Remove rear bench seat from vehicle.
 

Removing and installing bench seat / individual seats

Installing
Install in reverse order, but note the following:
–  Check body apertures -arrow- for deformation.
–  Repair any deformation using a plastic head hammer.
  Note
Slight remaining deformations are permissible.
–  Lift up floor covering -2- and press new mounting grommets -1- into body aperture -arrow- until they engage audibly.
–  Arrange floor covering around grommet as shown in illustration.
  Note
The floor covering must not cover the grommet.
 

Removing and installing bench seat / individual seats

–  Before installing the rear bench seat, check if the wire frame is aligned properly in the highlighted area -arrows-.
–  If the wire frame is bent, it must be bent back until it is properly aligned again.
–  Fit rear bench seat and press wire hooks firmly into mounting grommets.
–  Ensure that the wire hooks are properly engaged in the mounting grommets.
 

Removing and installing bench seat / individual seats

Assembly overview - remote release mechanism for seat backrest
  Note The illustration shows the remote release mechanism for seat backrest on the left side. The right-hand side is similar (mirror image of left-hand ...

Removing and installing rear seat backrest
Special tools and workshop equipment required         Torque wrench -V.A.G 1331 ...

Other materials:

Assembly overview - trailing arm, except for e-Golf
1 -  Cover 2 -  Bolt Renew after removing 50 Nm +45° 3 -  Mounting bracket 4 -  Bolt Renew after removing 90 Nm& ...

Assembly overview - sliding sunroof
1 -  Glass panel for panorama tilting sunroof (single pane safety glass) Removing glass panel → Chapter If drive defective, remove glass panel → Chapter Adjusting glass panel → Chapter 2 -  Bolt ...

Checking airbag securing parts after an accident
All damaged securing parts must always be renewed. It is not permissible to bend the components back into shape or »make them fit« The following components must be checked after the relevant airbag has been triggered. ...

© 2016-2024 Copyright www.vwgolf.org