Volkswagen Golf Service & Repair Manual: Removing and installing belt height adjuster, 2-door model
– |
Press belt height adjuster button and move slider of belt
height adjuster to lowest position. |
– |
Detach upper B-pillar trim
→ Chapter. |
– |
Place B-pillar trim with belt webbing attached to one side. |
|
|
|
– |
Initially, fit B-pillar trim -3-
upwards into mounting in roof. |
|
Mounting -2- of sliding part on
B-pillar trim must engage in retaining pin
-1- on belt height adjuster -arrow-. |
– |
If a new belt height adjuster is installed, firmly push
sliding part upwards after B-pillar trim has been installed. |
|
This will release the installation guard of the belt height
adjuster. |
– |
Check the following functions: |
|
Belt height adjuster must engage audibly in each of the 3
possible positions (including top position). |
|
Belt height adjuster button must return to top position
after any operation. |
|
Belt guide fitting must move to vertical position or
operated position on its own. |
If one of the requirements is not fulfilled, check belt
height adjuster for correct installation and renew it if
necessary. |
|
→ Chapter „Assembly overview - front three-point seat belt,
2-door model“ |
|
|
|
Removing
–
Unscrew bolt -1- on belt end
fitting -2-.
Installing
...
Removing
–
Press belt height adjuster button and move slider of belt
height adjuster to lowest position.
–&nbs ...
Other materials:
Synchronising the vehicle key
First read and observe the introductory information
and safety warnings It may no longer be possible to lock or unlock the vehicle
with the remote control if the button
is pressed repeatedly outside of the effective range of the vehicle key. If this
is the case, the vehicle ke ...
Safety precautions for working on vehicles with auxiliary heater
Danger of fire and explosion from auxiliary/supplementary heater
In fire and explosion-endangered areas a spark or the high
temperature of the auxiliary/supplementary heater can cause a fire or an
explosion. Burn injuries are also possible.
–
Swit ...
Overview of fitting locations – control units, front of RHD vehicles
1 -
Headlight range control unit -J431-/control unit for cornering light
and headlight range control -J745-
Assembly overview
→ Chapter
2 -
Interface for entry and start system -J965-
Assembly ...
© 2016-2024 Copyright www.vwgolf.org