Volkswagen Golf Service & Repair Manual: Removing and installing battery, vehicles without high-voltage system
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1331- |
|
|
|
Torque wrench -V.A.G 1783- |
WARNING
Always make sure to comply with the warning notices
and safety regulations when working on the battery
→ Electrical system, General information; Rep. gr.27. |
|
– |
Remove ignition key, if inserted. |
– |
Open cover in heat insulation sleeve. |
|
|
|
– |
Open cover -4- for negative
battery terminal. |
– |
Loosen nut -6- several turns
and disconnect battery terminal clamp -5-
of earth cable from negative battery terminal. |
– |
Open cover -3- for positive
battery terminal. |
– |
Loosen nut -2- several turns
and disconnect battery terminal clamp -1-
of positive cable from positive battery terminal. |
|
|
|
– |
Insert battery -A- into battery tray
-1- so that battery base strip lies against stop at back
and sides -arrows-. |
It should no longer be possible to move battery -A- towards
rear or sides. |
|
|
|
– |
Fit securing bracket -1-. |
Make sure that lug -arrow- on
securing bracket -1- engages into
recess in battery base strip. |
– |
Tighten bolt -2- for securing
bracket -1-. |
– |
Ensure that battery -A- is seated securely. |
With ignition and electrical equipment switched off, connect
battery -A- in the following sequence: |
– |
Fit battery terminal clamp -3-
of positive cable to positive battery terminal “+”. |
– |
Reconnect battery -A-
→ Chapter. |
Note
If the battery is renewed, the battery monitor control unit
-J367- must be adapted
→ Chapter. |
→ Chapter „Assembly overview – battery, vehicles without
high-voltage system“ |
|
|
|
1 -
Battery tray
2 -
Battery cover
3 -
Retaining clip
4 -
Nut
20 Nm
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Other materials:
Vehicle registration documents since 01-10-2005
The implementation of EU Directive 1999/37/EU "Registration
Documents for Vehicles" in national law and legal requirements
for data protection have necessitated the introduction of new,
falsification-proof registration documents.
Since 0 ...
Fixing position of subframe
Note
Certain repairs on vehicles require the removal of the
subframe or the entire front axle.
The original position of the subframe relative to the body
can be retained with the aid of qty. 4 locating pins -T10486/ ...
Removing and installing ambient temperature sensor -G17-
Removing
–
Remove radiator grille
→ General body repairs, exterior; Rep. gr.66.
–
Remove ambient temperature sensor -G17--1-
from bracke ...
© 2016-2024 Copyright www.vwgolf.org