Volkswagen Golf Service & Repair Manual: Removing and installing baffle plate, RHD vehicles

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Front heater and air conditioning unit / Removing and installing baffle plate, RHD vehicles

Removing

–	Depending on version, remove plastic bolt or plug -2- and remove baffle plate -1-.

Installing

–	Install in reverse order.

Note

Always replace plugs with plastic bolts → Electronic Parts Catalogue.

Specified torques:

Bolts -2- → Item.

Removing and installing baffle plate, RHD vehicles

Removing and installing baffle plate, LHD vehicles

Removing – Depending on version, remove plastic bolt or plug -2- and remove baffle plate -1 ...

Air duct

...

Other materials:

Removing and installing net partition
Removing – Fold down both rear seat backrests. – Pull net partition -1- towards right out of mountings -2- on right rear seat backrest (2/3), and remove it. Installing ...

Removing and installing cigarette lighter illumination bulb -L28-
Note On some vehicles, the illumination is not provided by a light bulb, but by an LED (light-emitting diode), depending on the equipment level. This LED is permanently attached to the retaining sleeve and cannot be renewed separately. ...

Assembly overview - suspension strut, shock absorber, spring, multi-link suspension
1 - Bolt Renew after removing 50 Nm +45° 2 - Shock absorber Removing and installing → Chapter Note correct installation position of cable tie fastener. ...