Volkswagen Golf Service & Repair Manual: Removing and installing baffle plate, LHD vehicles

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Front heater and air conditioning unit / Removing and installing baffle plate, LHD vehicles

Removing

–	Depending on version, remove plastic bolt or plug -2- and remove baffle plate -1-.

Installing

–	Install in reverse order.

Note

Always replace plugs with plastic bolts → Electronic Parts Catalogue.

Specified torques:

Bolts -2- → Item.

Removing and installing baffle plate, LHD vehicles

Removing and installing condensation drain (RHD)

Removing – Remove right centre console trim in footwell → General body repairs, interior; Rep. gr.68. ...

Removing and installing baffle plate, RHD vehicles

Removing – Depending on version, remove plastic bolt or plug -2- and remove baffle plate -1 ...

Other materials:

Removing and installing front interior light/reading light
Special tools and workshop equipment required Removal wedge -3409- Note The switch module is an integral part of the front interior light -WX1- and cannot be r ...

Removing and installing gas strut
Removing Note The rear lid must be supported when a gas strut is removed. One gas strut alone cannot support an open rear lid. – Open rear lid and brace it open. ...

Removing and installing heat exchanger for high-voltage battery
Special tools and workshop equipment required Hose clamps, up to 25 mm -3094- Engine bung set -VAS 6122- Pliers for spring-type clips -VAS 5024A- Cooling sy ...