Volkswagen Golf Service & Repair Manual: Removing and installing backrest cover and backrest padding
Volkswagen R GmbH, optional equipment
»R« |
Note
Removal and installation is described for the left seat.
Apply the same instructions for removal and installation of
right seat components as appropriate. |
Special tools and workshop equipment
required |
|
|
|
|
|
Removal wedge -3409 |
|
|
Upholstery clip pliers -V.A.G 1634 |
Only seats without through-loading function |
– |
Open beading strip -4- using front-end
hook -3438-. |
Only seats with through-loading function |
A zip fastener is installed instead of the beading strip
-4-. |
Continuation for all seats |
– |
Roll backrest cover -1- upwards at
front and rear. |
– |
Pull backrest cover -1- upwards in
order to gain access to the upholstery clips -5-
on left and right. |
– |
Open upholstery clips -5- using pliers
-6-. |
– |
Pull backrest cover -1- on padding
-7- upwards. |
– |
Pull backrest cover -1- further upwards
in order to gain access to the upholstery clips
-5-. |
– |
Detach clip -3- from backrest frame
-2- on both sides at the rear. |
– |
Use removal wedge -3409- for this. |
– |
Open upholstery clips -5- on backside. |
– |
Pull backrest cover -1- further upwards
in order to gain access to the upholstery clips
-5-. |
Note
The uppermost retaining clips need not be removed. |
Only for vehicles with entry assistance |
|
|
|
– |
Pull backrest cover on backside upwards up to cross bar
-2-. |
– |
Detach cross bar on left and right from seat frame
-arrows-. |
– |
Remove trim for locking mechanism
→ Chapter. |
Continued for all vehicles |
– |
Thread out backrest cover and backrest padding on head
restraint locking mechanism. |
– |
Remove backrest cover and backrest padding from backrest. |
– |
Thread out wiring harness while doing so. |
Install in reverse order, but note the following: |
– |
If necessary, install backrest heating element
→ Chapter. |
– |
Fit backrest cover on backrest padding
→ Chapter. |
|
→ Chapter „Assembly overview - cover and padding for backrest“ |
|
→ Chapter „Assembly overview - front seat“ |
|
→ Chapter „Assembly overview - front backrest“ |
|
|
|
Special tools and workshop equipment
required
Removal wedge -3409
...
Special tools and workshop equipment
required
Upholstery clip pliers -V.A.G 1634
...
Other materials:
Checking child seat anchors after an accident
Points to check
Child seat anchors must be checked for damage and
deformation after an accident.
Child seat anchors welded to the body or the seats/backrests
or bolted in place may not be repaired or straightened.
...
Overview of fitting locations – controls in roof trim
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Driver vanity mirror contact switch -F147-
The vanity mirror contact switch is as integral part of the sun
v ...
Introduction
This chapter contains information on the following subjects:
→ Stowing items of luggage
→ Driving with an open tailgate
→ Driving a loaded vehicle
→ Vehicle-specific weight ratings
Heavy objects must always be stowed securely in the luggage comp ...
© 2016-2024 Copyright www.vwgolf.org