Volkswagen Golf Service & Repair Manual: Removing and installing B-pillar trim on rear door
Note
| Removal and installation are described only for the left side.
Removal and installation of the right side are similar. |
| – |
Run door window down to bottom position. |
| – |
Pull window channel -3- in area of
B-pillar trim-1- out of door frame. |
| – |
Unclip spreader rivets -2-. |
| – |
Push B-pillar trim -1- downwards and
pull off door frame. |
| – |
Pull out B-pillar trim -1- upwards. |
| – |
Insert B-pillar trim -1- on door frame. |
| – |
Fit B-pillar trim -1- in longitudinal
holes -4- in frame section. |
| – |
Position B-pillar trim -1- and push
until stop. |
| – |
Push B-pillar trim -1- upwards until it
is in contact with window channel -3-. |
| – |
Hook in spreader rivet -2- from top to
bottom and insert window channel -3- into
B-pillar trim. |
Note
Removal and installation are described only for the left side.
Removal and installation of the right side are similar.
Removing
–
...
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
–
Removing centre u ...
Other materials:
Overview - rear axle, multi-link suspension
I -
→ Chapter „Subframe“
II -
→ Chapter „Anti-roll bar“
III -
→ Chapter „Suspension link, track rod“
IV&n ...
Repairing subframe
Special tools and workshop equipment required
Assembly tool -T10205-
Torque wrench -V.A.G 1332-
Hydraulic press -VAS 6178-
Foot pump -VAS 6179-
Assembly tool -VAS 6779-
...
Radio
Layout - radio, Composition Touch and
Composition Colour radio version
The radio -R- is installed in the middle of the dash panel.
Fault finding is done via Guided fault
finding
→ Vehicle diagnostic test ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing B-pillar trim on front door
Removing and installing underbody heat shield