Volkswagen Golf Service & Repair Manual: Removing and installing B-pillar trim, 2-door models

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Trim, noise insulation / Interior trims / Removing and installing B-pillar trim, 2-door models

Special tools and workshop equipment required

Wedges -T10383

Removing

Upper part of B-pillar trim

Note

Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate.

–	Remove front belt end fitting → Chapter.

–	Move belt height adjuster to lowest position.

Removing and installing B-pillar trim, 2-door models

–	Lever out cap -3- marked with an “airbag” symbol using a screwdriver.

–	Remove bolt -2-.

–	Release side trim panel in area of overlap to upper B-pillar trim -1- → Chapter.

–	Starting at bottom, detach upper B-pillar trim -1- from door seal and release it from retaining clips -arrows A- using wedge -T10383-.

–	Pull upper B-pillar trim -1- out of body mounting -arrow C-. To do this, swing trim towards inside and simultaneously pull it off downwards.

–	Thread out belt webbing through slider for belt height adjuster and remove upper B-pillar trim.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.
Following installation, ensure that the upper B-pillar trim is positioned in door seal beading.

Installation is carried out in reverse order.

Specified torques

→ Chapter „Assembly overview - B-pillar trim“

Removing and installing B-pillar trim, 4-door models and estate

Special tools and workshop equipment required Wedges -T10383 &n ...

Removing and installing C-pillar trim, saloon

Note Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate. ...

Other materials:

Removing and installing manually operated or automatic anti-dazzle interior mirror, with rain and light sensor -G397- and without front camera for driver assist systems -R242-
Removing – Swing interior mirror downwards by approx. 25° as far as stop. – Pull rear cover -2- downwards -arrow- while simultaneously releasing catches -1- using a screwdriver. ...

Starter button
Fig. 129 In the lower part of the centre console: starter button for the Keyless Access locking and starting system Fig. 130 Emergency start function in vehicles with Keyless Access First read and observe the introductory information and safety warnings The starter button can only be ope ...

Maximum permitted gross combination weight
First read and observe the introductory information and safety warnings All data in the official vehicle documents take precedence over these data. All data in this manual apply to the basic German model. The vehicle data sticker in the service schedule and the official vehicle documents sho ...