Volkswagen Golf Service & Repair Manual: Removing and installing automatic distance control unit, variant 1
Note
If the automatic distance control unit -J428- is renewed,
start the respective function → Vehicle
diagnostic tester. |
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1331- |
|
|
|
– |
Remove adaptive cruise control unit -J428--2-. |
– |
Disconnect electrical connector -1-. |
Removing trim for radar sensor |
|
|
|
– |
Release retaining tabs of trim for radar sensor
-2- on both sides in direction of
arrow -A-. |
– |
Remove trim for radar sensor -2-
from adaptive cruise control unit -J428--1-. |
Install in the reverse order of removal, observing the
following: |
– |
Calibrate adaptive cruise control
→ Chapter. |
→ Chapter „Overview of fitting locations – adaptive cruise
control, variant 1“ |
|
|
|
1 -
Dash panel insert -KX2-
With control unit in dash panel insert -J285-.
Removing and installing
→ Chapter
2& ...
Removing:
→ Anchor
Installing:
→ Anchor
Adjusting adjustment screws:
→ Anchor
...
Other materials:
Preface
The contents of this guide are separated into two parts.
The first part contains information and important notes on
the subject of “Trailer operation”. The technical prerequisites
for towing trailers or the function of the trailer control ...
Perform battery test with battery tester with printer -VAS 6161-.
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
Special tools and workshop equipment
required
...
Charge factor
There must be space both for liquid and vapour in a
container. As the temperature rises, the liquid expands. The
space occupied by the vapour becomes smaller. Eventually, there
will only be liquid in the container. After that time, even a
small increase ...
© 2016-2024 Copyright www.vwgolf.org