Volkswagen Golf Service & Repair Manual: Removing and installing anti-theft alarm sensor -G578-, version with 4 bolts
Special tools and workshop equipment
required |
|
|
|
Caution
Danger of damage to component surfaces. |
When using leverage tools, mask visible areas of the
component with commercially available adhesive tape. |
|
– |
Remove front interior light -WX1-
→ Chapter. |
|
|
|
– |
Using removal wedge -3409-, lever off cover
-1- in vicinity of
-arrows-. |
– |
Remove roof module -2-. |
– |
Disconnect electrical connector. |
|
|
|
– |
Release retaining tabs in direction of arrows
-A- and -B-. |
– |
Remove anti-theft alarm sensor -G578--1-
from roof module. |
|
|
|
– |
Release retaining tabs in direction of arrows
-A- and -B-. |
– |
Remove single sensor -1- from
roof module. |
Install in the reverse order of removal, observing the
following: |
Note
The anti-theft alarm sensor -G578- needs to be parameterised
after renewal. |
– |
Parameterise anti-theft alarm system sensor -G578-
→ Vehicle diagnostic tester. |
→ Chapter „Assembly overview - interior monitor“ |
|
|
|
Removing
–
Remove front interior light -WX1-
→ Chapter.
–&n ...
Removing and installing front camera for
driver assist systems
Removing
–
Switch off ignition and all electrical ...
Other materials:
Checking swivel joint
Checking axial play
–
Firmly pull suspension link down in
-direction of arrow- and press up again.
Checking radial play
–
Press l ...
General notes
Cleanliness specifications for working on
the auxiliary heater and fuel system
When working on the fuel supply and injection system, pay
careful attention to the following “rules”:
Thoroughly clean all unions a ...
Information stored in the control units
First read and observe the introductory information
and safety warnings Your vehicle is factory fitted with electronic control
units which are responsible for engine and gearbox management. The control units
also monitor the function of the exhaust system and the airbags.
These electronic ...
© 2016-2024 Copyright www.vwgolf.org