Volkswagen Golf Service & Repair Manual: Removing and installing anti-theft alarm sensor -G578-, version with 2 bolts

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches inside, anti- theft system / Anti-theft alarm system / Removing and installing anti-theft alarm sensor -G578-, version with 2 bolts

Removing

–	Remove front interior light -WX1- → Chapter.

–	Remove bolts -2-.

–	Remove roof module -1- in direction of arrow -A-.

–	Disconnect electrical connector.

Removing and installing anti-theft alarm sensor -G578-, version with 2 bolts

–	Release retaining tabs in direction of arrows -A- and -B-.

–	Remove anti-theft alarm sensor -G578--1- from roof module.

Removing and installing anti-theft alarm sensor -G578-, version with 2 bolts

–	Release retaining tabs in direction of arrows -A- and -B-.

–	Remove single sensor -1- from roof module.

Installing

Install in the reverse order of removal, observing the following:

Note

The anti-theft alarm sensor -G578- needs to be parameterised after renewal.

–	Parameterise anti-theft alarm system sensor -G578- → Vehicle diagnostic tester.

–	Test functionality.

Specified torques

→ Chapter „Assembly overview - interior monitor“

Removing and installing anti-theft alarm sensor -G578-, version with 2 bolts

Removing and installing alarm horn -H12-

Removing – Remove plenum chamber cover → General body repairs, exterior; Rep. gr.50. ...

Removing and installing anti-theft alarm sensor -G578-, version with 4 bolts

Special tools and workshop equipment required Removal wedge -3409- Removing ...

Other materials:

Golf BlueMotion - from model year 2013, sales type 5G1
Note The specified wheel and tyre combinations apply for all the gearboxes allocated to the respective engines. Deviations from this are specially indicated in the table. Depending on equipment, the wheel-and-tyre combination 185/70 R15 on ...

Dismantling and assembling drive shaft, triple roller joint AAR3300i
Special tools and workshop equipment required Thrust plate -VW 401- Thrust plate -VW 402- Press tool -VW 408 A- Press tool -VW 411- Tube -VW 416 B- Th ...

Removing and installing output module for headlight -J667-/-J668-
WARNING Risk of death due to high voltage! Risk of injury and environmental pollution! Observe operation and safety notes for gas discharge bulbs → Chapte ...