Volkswagen Golf Service & Repair Manual: Removing and installing anti-roll bar
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1331- |
Note
The following procedure is described for the left side of
the vehicle. The procedure for the right side of the vehicle is
identical. |
|
|
|
– |
Unscrew bolts -arrows- for
anti-roll bar -1-. |
|
|
|
– |
Unscrew nut -1- from coupling
rod -2-. |
– |
Pull coupling rod -2- out of
anti-roll bar -3-. |
– |
Remove anti-roll bar -3- from
subframe. |
Install in reverse order of removal, observing the
following: |
|
|
|
– |
Tighten bolts -arrows- for
anti-roll bar -1- evenly on
subframe -2-. |
→ Chapter „Assembly overview - anti-roll bar“ |
→ Chapter „Torque settings for wheel bolts“ |
|
|
|
1 -
Lower transverse link
2 -
Nut
Renew after removing
20 Nm +180°
3 -
Coupling ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Re ...
Other materials:
Removing and installing spring, torsion beam axle
Special tools and workshop equipment
required
Spring compressor -V.A.G 1752/1-
Spring retainer -V.A.G 1752/3A-
...
Wheel bolts
Fig. 222 Changing a wheel: loosening the
wheel bolts
Fig. 223 Changing a wheel: tyre valve ①
and locations of the anti-theft wheel bolt ② or ③
First read and observe the introductory information
and safety warningsOnly the spanner delivered with the vehicle should be
used to loosen ...
Overview of fitting locations – control units, front of RHD vehicles
1 -
Headlight range control unit -J431-/control unit for cornering light
and headlight range control -J745-
Assembly overview
→ Chapter
2 -
Interface for entry and start system -J965-
Assembly ...
© 2016-2024 Copyright www.vwgolf.org