Volkswagen Golf Service & Repair Manual: Removing and installing alternator, vehicles with 2.0 l TSI engine

Volkswagen Golf Service & Repair Manual / Electrical system / Starter- current supply- CC / Alternator / Removing and installing alternator, vehicles with 2.0 l TSI engine

Special tools and workshop equipment required

Torque wrench -V.A.G 1331-

Removing and installing alternator, vehicles with 2.0 l TSI engine

Engine bung set -VAS 6122-

Removing

–	With ignition switched off, disconnect earth cable from battery -A- → Chapter.

–	Remove radiator cowl → Rep. gr.19.

–	Remove poly V-belt → Rep. gr.13.

Removing and installing alternator, vehicles with 2.0 l TSI engine

–	Unscrew bolts -1- and -2-.

Removing and installing alternator, vehicles with 2.0 l TSI engine

–	Release hose clips -1- and -2-, and remove air intake hose.

–	Seal open lines and connections with suitable plugs from engine bung set -VAS 6122-.

Removing and installing alternator, vehicles with 2.0 l TSI engine

–	Lay coolant hose -3- to one side.

–	Loosen hose clip -2-.

–	Remove bolts -arrows-.

–	Disconnect electrical connector -1-.

–	Remove air pipe (right-side).

Vehicles with air conditioner

Caution

Risk of damage to air conditioner compressor, refrigerant lines and refrigerant hoses:

Make sure refrigerant lines and hoses are not excessively stretched, kinked or bent.

–	Remove air conditioner compressor from bracket → Heating, air conditioning system; Rep. gr.87.

–	Secure air conditioner compressor to lock carrier so that refrigerant lines are not under tension.

Continued for all vehicles

Removing and installing alternator, vehicles with 2.0 l TSI engine

–	Move electrical wiring harness clear -arrow-.

–	Unscrew bolts -5- and -6-, and move alternator -C--4- towards front.

–	Disconnect electrical connector -3-.

–	Pry off cap -2-.

–	Unscrew nut and remove terminal 30/B+ -1-.

–	Remove alternator -C--4- downwards (towards centre of vehicle).

Installing

Install in the reverse order of removal, observing the following:

–	Reconnect battery -A- → Chapter.

–	Always start engine and check belt running after completing work.

Specified torques

→ Chapter „Assembly overview - alternator“

Removing and installing alternator, vehicles with 2.0 l TSI engine

Removing and installing alternator, vehicles with 1.2 l TSI engine, 1.4 l TSI engine and 1.4 l TSI natural gas engine

Special tools and workshop equipment required Torque wrench -V.A.G 1331- Removin ...

Removing and installing alternator, vehicles with TDI engine

Special tools and workshop equipment required Torque wrench -V.A.G 1331- ...

Other materials:

Wiring open circuit with two repair positions
Repair position with interlinked wire. – Place the wire to be repaired to the side at two points (about 20 cm to both sides of the relevant repair position). – If necessary, unbind the wiring harnes ...

Removing and installing guide for ISOFIX child seat anchor
Removing – Unclip cover -1- from ISOFIX child seat anchor -arrow- and remove it. – Push guide -1- downwards out of recess and detach it from ...

Removing and installing headlight dipped beam bulb (dual halogen headlights)
Note Left headlight dipped beam bulb -M29- and right headlight dipped beam bulb -M31- are only fitted on dual halogen headlights. Removal and installation are described for the left side. Removal and installati ...