Volkswagen Golf Service & Repair Manual: Removing and installing alternator, vehicles with 1.2 l TSI engine, 1.4 l
TSI engine and 1.4 l TSI natural gas engine
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1331- |
– |
With ignition switched off, disconnect earth cable from
battery -A-
→ Chapter. |
– |
Remove poly V-belt
→ Rep. gr.13. |
– |
Remove tensioner for poly V-belt
→ Rep. gr.13. |
Vehicles with air conditioner |
Caution
Risk of damage to air conditioner compressor,
refrigerant lines and refrigerant hoses: |
Make sure refrigerant lines and hoses are not
excessively stretched, kinked or bent. |
|
– |
Remove air conditioner compressor from bracket
→ Heating, air conditioning system; Rep. gr.87. |
– |
Secure air conditioner compressor to lock carrier so that
refrigerant lines are not under tension. |
Continued for all vehicles |
|
|
|
Note
If alternator -C--1- is stuck
in its bracket, screw bolts in again except for the last 2
turns. |
Carefully hit bolt heads with flat side of hammer to release
sliding bushes of alternator mounting. |
|
|
|
– |
Remove alternator -C--1- from
bracket with electrical wiring still connected. |
– |
Disconnect electrical connector -3-. |
– |
Unscrew nut and remove terminal 30/B+
-4-. |
– |
Remove alternator -C--1-
downwards to the right. |
Install in the reverse order of removal, observing the
following: |
– |
To facilitate positioning of alternator -C-, slide bushes of
alternator mounting slightly towards back. |
Note
Ensure that bushes of alternator mounting slide freely and
are not to tight (loosen, if necessary); otherwise clamping
force of sliding bushes is too low even if specified torque is
applied. |
– |
Reconnect battery -A-
→ Chapter. |
– |
Always start engine and check belt running after completing
work. |
→ Chapter „Assembly overview - alternator“ |
|
|
|
1 -
Alternator -C-
Removing and installing
→ Chapter
Checking
→ Chapter
Removing and install ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Other materials:
Reservoir
The reservoir collects the vaporised and gaseous mixture
coming from the evaporator to ensure the air conditioner
compressor receives only gaseous refrigerant. Gaseous
refrigerant is formed from the vapour.
Refrigerant oil flowing in the ...
Removing and installing belt height adjuster, 4-door model and estate
Removing
–
Press belt height adjuster button and move slider of belt
height adjuster to lowest position.
–
Detach upper B-pillar trim
→ Chapter.
–
...
Bleeding coolant circuit of auxiliary heater
The removal and installation procedures for the auxiliary
heater and the circulation pump -V55- described in this Workshop
Manual ensure that only a small quantity of air enters or
remains in the coolant circuit. Therefore it is not necessary to
bleed th ...
© 2016-2024 Copyright www.vwgolf.org