VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing accelerator module -GX2-

Removing
   
–  Fold floor covering -1- forwards in -direction of arrow-.
 

Removing and installing accelerator module -GX2-

–  Release and pull off connector -2- on accelerator pedal module -GX2-.
–  Remove bolt -1-.
–  Detach accelerator pedal module -3- from mounting.
Installing
Install in reverse order. In the process, note the following:
Specified torques
→ Chapter „Assembly overview - accelerator module“
 

Removing and installing accelerator module -GX2-

Assembly overview - accelerator module
1 -  Bolt 6 Nm 2 -  Electrical connector Make sure it is engaged properly; pull to check that plug-in con ...

Fuel pump
...

Other materials:

Assembly overview - coolant temperature sender
1 -  O-ring Renew 2 -  Radiator outlet coolant temperature sender -G83- Removing and installing → Chapter 3 -  Support ring 4 -  O-ring ...

Rear view
Fig. 3 Overview of the rear of the vehicle Key for  : High-mounted brake light Rear window Rear window heating   Rear wiper   Tail light cluster     Tailgate   Rear sensors for the ParkPilot or Park Assist system     Mounting for the rear to ...

Removing and installing seat trim on sill side, seat of type "ergo Aktiv"
  Note Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate. Special tools and workshop equipment required     ...

© 2016-2024 Copyright www.vwgolf.org