Volkswagen Golf Service & Repair Manual: Removing and installing A-pillar gap cover
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate. |
Special tools and workshop equipment
required |
|
|
|
|
|
Removal wedge -3409 |
– |
Remove side dash panel cover
→ Chapter. |
– |
Unclip A-pillar gap cover -1-
from upper A-pillar trim and lower A-pillar trim
-arrows-. |
– |
Release A-pillar gap cover -1-
from door seal beading and remove it. |
Note
Following installation, ensure that the A-pillar gap
cover is positioned in door seal beading. |
Installation is carried out in reverse order. |
|
|
|
Note
Removal and installation are described for the left vehicle
side. Follow same instructions for the right side as
appropriate.
...
Special tools and workshop equipment
required
Removal wedge -3409
...
Other materials:
1-pack clear coat
Designation:
1-pack clear coat -LLS MAX 010-
Issued 10.2008
Product description
The 1-pack clear coat -LLS MAX 010- is a one-pack product.
The raw material basis is acrylic r ...
Removing and installing wiper motor -V-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Torque wrench -V.A.G 1331-
Note ...
Removing and installing trim for backrest release mechanism
Removing
–
Pull operating lever -1-
upwards -arrow A-.
–
Insert flat-bladed screwdriver between trim and operating
lever as shown in illustration.
–
Releas ...
© 2016-2024 Copyright www.vwgolf.org