Volkswagen Golf Service & Repair Manual: Rear seats
- Assembly overview - bench seat / individual seats
- Assembly overview - rear seat backrest
- Assembly overview - locking mechanism
- Assembly overview - centre armrest
- Assembly overview - side padding
- Assembly overview - remote release mechanism for seat backrest
- Removing and installing bench seat / individual seats
- Removing and installing rear seat backrest
- Removing and installing trim for locking mechanism
- Removing and installing locking mechanism for rear seat backrest
Removing and installing massage control unit -J740-
Special tools and workshop equipment
required
Removal wedge -3409
...
Assembly overview - bench seat / individual seats
1 -
Rear bench seat
Allocation
→ Electronic Parts Catalogue
Removing and installing
→ Chapter
2 -
Guide
...
Other materials:
Removing and installing tyre pressure sensor, Siemens tyre pressure
monitoring system
WARNING
After tyre sealant has been used, the tyre pressure
sensor of the respective wheel must be renewed.
The Siemens system does not have a micro-encapsulated bolt.
...
Fitting control unit to hydraulic unit
Special tools and workshop equipment
required
ESD workplace -VAS 6613-
Torque screwdriver -V.A.G 1624-
Torx bit T25
Severe ...
Bringing air conditioning system into service after charging
Note
If the air conditioner compressor was removed, the V-belt
pulley /freewheel must be turned by hand approx. 10 times prior
to initial operation. This prevents any damage occurring from a
fluid hammer in the air conditioner compressor when th ...
