Volkswagen Golf Service & Repair Manual: Programming sliding sunroof adjustment control unit -J245-
Note
-
|
If a glass panel, motor or tilt mechanism have been renewed,
adaption needs to be performed. |
-
|
The anti-trap function is switched off during adaptation. |
Establishing reference points of sliding sunroof motor |
– |
Pull button backwards -arrow a-, and
hold it in this position during entire programming process (approx.
20 sec). |
– |
When establishing reference points, glass panel first closes and
then moves approx. 200 mm towards the rear. |
– |
Once glass panel has closed again, the programming run is finished
and rotary knob can be released. |
Special tools and workshop equipment
required
Removing
Torque wre ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Indicator lamp
→ Catalytic converter
→ Diesel particulate filter
Additional information and warnings:
Changing gear
Filling the tank
Fuel
Engine oil
Battery
Info ...
Removing and installing Bowden cable
Removing
–
Open bonnet.
–
Remove release lever
→ Chapter.
–
Remove Bowden cable -3- from mounting
bracket -5--arrow a-.
– ...
Secondary locking element
The secondary locking mechanism is a housing catch (second
line locking mechanism) that secures all the wires in one
contact housing. If a secondary locking mechanism is fitted to a
contact housing, this must always be opened or removed using the
appropr ...
© 2016-2024 Copyright www.vwgolf.org