Volkswagen Golf Service & Repair Manual: Preparing old undamaged windows for fitting
Cutting back adhesive bead |
WARNING
Keep bonding surface free of dirt and grease. |
Do not treat bonding surface with activator
immediately after cutting back. Do not prime. Do not
treat with cleaning solution. |
|
Note
|
|
|
|
If an undamaged window is being re-used, cut back the
residual adhesive sealant to 1 to 2 mm shortly before bonding it
back in. Do not damage primer and ceramic coating when doing
this. |
|
The remaining material is required as a base for the new
adhesive sealing material. |
WARNING
Exception: if bonding is performed later than one
day after cutting back adhesive bead, the remaining
residual material must be activated with activator. |
Apply activator evenly in one stroke using
applicator. |
Activator must not come in contact with paint, or
the paintwork will be damaged. |
Drying time approx. 10 minutes |
|
|
|
|
Note
Before renewing windscreen, explore possibilities of
repairing damage to glass.
Damag ...
Note
The area on which the adhesive bead is applied is not
precoated or primed.
The seali ...
Other materials:
Removing and installing roof spoiler
Removing
Note
The side spoiler remains installed.
–
Remove rear lid trim
→ General body repairs, interior; Rep. gr.70.
–&nb ...
Stowage compartment in the front centre armrest
Fig. 112 Stowage compartment in the front
centre armrest
First read and observe the introductory information
and safety warnings To open, pull the centre armrest all the way up
in the direction of the arrow .
To close, guide the armrest down.
WARNING
The centre armrest can obstruct ...
Removing and installing drive shaft
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Press tool -T10520-
...
© 2016-2024 Copyright www.vwgolf.org