Volkswagen Golf Service & Repair Manual: Overview of fitting locations – control units, rear
| 1 - | Remote control receiver for auxiliary coolant heater -R149- |
| Removing and installing remote control receiver for auxiliary coolant heater -R149- → Heating, Air conditioning; Rep. gr.82 |
| 2 - | Two-way signal amplifier for mobile telephone/data services -J984- |
| Assembly overview → Electrical system; Rep. gr.91 |
| 3 - | Engine sound generator control unit -J943- |
| Removing and installing → Chapter „Removing and installing engine sound generator control unit -J943-, vehicles with active sound, Golf GTD“ |
| 4 - | Bolt |
| Qty. 2 |
| Specified torque: 2 Nm |
| 5 - | Electronically controlled damping control unit -J250- |
| Assembly overview → Running gear, axles, steering; Rep. gr.43 |
| 6 - | Trailer detector control unit -J345- |
| → Chapter „Assembly overview - towing bracket socket“ |
Overview of fitting locations – control units, front of RHD vehicles
1 -
Headlight range control unit -J431-/control unit for cornering light
and headlight range control -J745-
Assembly overview
→ Chapter
...
Assembly overview - control units, LHD vehicles
1 -
Control unit
Versions with parking aid:
Parking aid control unit -J446-
Assembly overview
→ Chapter
...
Other materials:
Vibration, conducting a road test before balancing wheels
If a customer brings a vehicle to the workshop complaining
about “vibration”, a road test is essential prior to balancing
the wheels.
This will give you information about the nature of the
vibration.
...
Removing and installing headlight dipped beam bulb (LED)
Special tools and workshop equipment
required
Front-end hook -3370-
Torque wrench -V.A.G 1783-
...
Adjusting camber at front wheels
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Note
Camber correction is necessary only after body repairs.
Camber cannot be ad ...
