Volkswagen Golf Service & Repair Manual: Overview of fitting locations – central locking

Volkswagen Golf Service & Repair Manual / General body repairs, exterior / Front door, central locking / Central locking / Overview of fitting locations – central locking

Overview of fitting locations – central locking

1 -	Coupling station

Fitting location: right A-pillar
To separate connections, release bellows at pillar

2 -	Onboard supply control unit -J519-

Location: Under dash panel on driver side
Removing → Electrical system; Rep. gr.97

3 -	Front passenger door control unit -J387-

Installed in door separated from window regulator motor.

4 -	Front right door lock

Door lock is secured to inner part of door
Electric central locking is integrated into door lock
Removing → Chapter

5 -	Coupling station

Fitting location: right B-pillar.
To separate connections, release bellows at pillar

6 -	Driver door control unit -J386-

Installed in door separated from window regulator motor

7 -	Rear right door lock

Door lock is secured to inner part of door
Electric central locking is integrated into door lock
Removing → Chapter

8 -	Coupling station, right side of rear lid

Location: behind C-pillar trim
Remove and install → General body repairs, interior; Rep. gr.70.

9 -	Release element with button

Location: Bolted to rear lid.
Removing → Chapter

10 -	Rear lid lock

Location: bolted to rear lid
Removing → Chapter

11 -	Coupling station, left side of rear lid

Location: behind C-pillar trim
Remove and install → General body repairs, interior; Rep. gr.70

12 -	Rear left door lock

Door lock is secured to inner part of door
Electric central locking is integrated into door lock
Removing → Chapter

13 -	Rear left door control unit -J388-

Installed in door separated from window regulator motor

14 -	Coupling station

Location: left B-pillar
To separate connections, release bellows at pillar.

15 -	Front left door lock

Door lock is secured to inner part of door
Electric central locking is integrated into door lock
Removing → Chapter

16 -	Driver door control unit -J386-

Installed in door separated from window regulator motor.

17 -	Central switch for window regulators

Location: installed in door panel
Remove and install central switch for window regulator → Electrical system; Rep. gr.96

18 -	Button for central closing

Location: installed in door panel
Remove and install button for central closing → Electrical system; Rep. gr.96.

19 -	Coupling station

Location: left A-pillar
To separate connections, release bellows at pillar.

20 -	Alarm horn -H12-

Removing → Electrical system; Rep. gr.96.

21 -	Bonnet contact switch -F266-

Contact switch for anti-theft alarm
Location: on bonnet lock
Removing → Chapter

Central locking

...

Removing and installing ignition key battery

Removing – Folding out key bit -1--arrow a-. – Use a small screw ...

Other materials:

Removing and installing driver side footwell vents, RHD vehicles
Removing Pyrotechnic components may trigger unintentionally.Risk of injury.Discharge any static charge accumulated in your body by briefly touching striker plate for door. – Remove driver side knee airbag → Genera ...

Removing and installing front air distribution flap control motor -V426-, LHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: – Switch off all electrical consumers. – ...

Gaskets, seals
After removing gaskets and seals, always inspect contact surface of housing or shaft for burrs resulting from removal or for other signs of damage. Before installing seals, lightly oil outer diameter and half-fill space between sea ...