Volkswagen Golf Service & Repair Manual: Overview of fitting locations - operating and display unit, air conditioning system with electric/manual controls

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Operating and display unit / Overview of fitting locations - operating and display unit, air conditioning system with electric/manual controls

Note

A warning lamp in the instrument panel controls will indicate that the selected function is active.

If the warning lamp does not light up after the AC button is pressed, a fault may be stored in the control unit. Call up event memory using vehicle diagnostic tester. If the entry “Compressor first run not performed” is stored in the event memory, a “Compressor first run” adaption must be carried out in "Guided fault finding" or "Guided functions".

In vehicles with start-stop system, note abort conditions: → Chapter

Overview of fitting locations - operating and display unit, air conditioning system with electric/manual controls

1 -	Left seat heating button -E653-

Optional

Seat heater has 3 heat settings. Current setting is shown by LED.

If no LED is lit, seat heating is switched off.

2 -

AC button

If the AC button is deactivated, the air conditioner compressor will be set to almost zero delivery.

3 -	Heated rear window button

Depending on ambient temperature, rear window heating will remain on from 4 to 20 minutes.

4 -	Air recirculation button

Note

Air recirculation mode changes to fresh air mode when ignition is switched off.

5 -	Instant heat button for switching auxiliary heater On/Off or OFF button for switching heater and air conditioning unit On/Off

Depending on equipment

OFF button activated, Climatronic out of operation. There is no heating and ventilation.

6 -	Right seat heating button -E654-

Optional

Seat heater has 3 heat settings. Current setting is shown by LED.

If no LED is lit, seat heating is switched off.

7 -	Rotary knob for setting air distribution

8 -	Display for air distribution

9 -	Rotary knob for setting blower speed

Left: reduce blower speed.

Right: increase blower speed.

10 -	Display for blower speed

11 -	Rotary knob for setting temperature

Left: reduce temperature.

Right: increase temperature.

12 -	Temperature setting display

Operating and display unit

...

Overview of fitting locations - operating and display unit, Climatronic

Note A warning lamp in the instrument panel controls will indicate that the selected function is active. In addition, the display of the radio or ...

Other materials:

Removing and installing spring, multi-link suspension, left spring for front-wheel drive, left and right spring for four-wheel drive
Special tools and workshop equipment required Spring compressor -V.A.G 1752/1- Spring retainer -V.A.G 1752/3A- ...

Loading the roof carrier
First read and observe the introductory information and safety warnings Loads can only be attached securely when the roof carrier system is fitted correctly . Maximum permissible roof load The maximum permitted roof load is 75 kg. The roof load limit refers to the combined weight of t ...

Removing and installing left vent temperature sender -G150
Special tools and workshop equipment required Vehicle diagnostic tester Removing Note Only on vehicles with Climatronic. On vehicles with heater or air conditioning syste ...