Volkswagen Golf Service & Repair Manual: Overview of fitting locations - fuel supply system, Golf and Golf GTE
 Note
| Fuel lines are secured with O-type clips. These O-type clips
must always be renewed every time they are removed. |
| Start engine if fuel tank was empty. Then start the
auxiliary heater repeatedly until the heater does not switch off
by itself. |
| Observe the rules for cleanliness when doing all work on the
fuel supply system
→ Chapter. |
| Always observe the safety precautions when working on the
fuel supply system
→ Chapter. |
|
|
|
| 1 - |
Fuel line to metering pump -V54- |
| With auxiliary heater control unit -J364-. |
| Location: behind front bumper cover on right |
| Removing and installing
→ Chapter |
| 3 - |
Quick-release coupling of fuel line |
| 4 - |
Quick-release coupling of fuel line |
| The metering pump -V54- is located on the fuel tank. |
| Removing and installing
→ Chapter |
| Testing quantity of fuel delivered
→ Chapter. |
| Fuel delivery unit can be found on right under bench seat. |
| With fuel gauge sender -G- |
| Removing and installing
→ Rep. gr.20 |
Note
Fuel lines are secured with O-type clips. These O-type clips
must always be renewed every time they are removed.
Star ...
Other materials:
Assembly overview - suspension strut, upper suspension link
1 -
Spring seat
Note correct installation position
2 -
Shock absorber
Different versions are possible. Refer to
→ Electronic Parts Catalogue “ETKA”.
3 -
Bolt
...
Identification plates
There are different types of identification plates.
When the auxiliary heater is replaced, check the type plate
and the duplicate plate and replace as necessary.
Identification plate on ...
Assembly overview - D-pillar trim
Note
The illustration shows the D-pillar trim on the left side. The
right-hand side is similar (mirror image of left-hand side).
1 -
D-pillar trim
Removing and installing
→ Chapter
2 -
Retaining cli ...
© 2016-2026 Copyright www.vwgolf.org
Overview of fitting locations - fuel supply system, Golf Variant