Volkswagen Golf Service & Repair Manual: Overview of fitting locations - front control motors, Climatronic, RHD
vehicles
| 1 - |
Control motor for fresh air and air recirculation flap and air flow
flap -V425- |
| With potentiometer for fresh air/recirculated air and air flow flap
control motor -G644-. |
| Checking: with vehicle diagnostic tester |
| Removing and installing
→ Chapter. |
| Renewing: initiate basic setting using vehicle diagnostic tester. |
| 2 - |
Front air distribution flap control motor -V426- with potentiometer
for front air distribution flap control motor -G642- |
| With potentiometer for front air distribution flap control motor
-G642-. |
| Checking: with vehicle diagnostic tester |
| Removing and installing
→ Chapter. |
| Renewing: initiate basic setting using vehicle diagnostic tester. |
| 3 - |
Left temperature flap control motor -V158- |
| With potentiometer for left temperature flap control motor -G220-. |
| Checking: with vehicle diagnostic tester |
| Removing and installing
→ Chapter. |
| Renewing: initiate basic setting using vehicle diagnostic tester. |
| 4 - |
Defroster flap control motor -V107- |
| With potentiometer for defroster flap control motor -G135-. |
| Checking: with vehicle diagnostic tester |
| Removing and installing
→ Chapter. |
| Renewing: initiate basic setting using vehicle diagnostic tester. |
| 5 - |
Right temperature flap control motor -V159- |
| With potentiometer for right temperature flap control motor -G221- |
| Checking: with vehicle diagnostic tester |
| Removing and installing
→ Chapter. |
| Renewing: initiate basic setting using vehicle diagnostic tester. |
In vehicles with start-stop system, note abort conditions:
→ Chapter
1 -
Left temperature flap ...
Heater and air conditioning system with electric/manual
controls
Special tools and workshop equipment
required
Veh ...
Other materials:
Contents
Fig. 217 Contents of the vehicle toolkit
First read and observe the introductory information
and safety warningsThe content of the vehicle toolkit depends on the vehicle
equipment level. The following describes the maximum scope.
The vehicle toolkit contains the following
Screwdriver w ...
Removing and installing catalytic converter
Note
The catalytic converter is removed together with the front
exhaust pipe.
Special tools and workshop equipment
required
High-temperature paste
→ Electronic Parts Catalogue.
...
Vehicles with torsion beam axle
Removing
–
If fitted, remove rear left underbody trim
→ General body repairs, exterior; Rep. gr.66.
–
Remove rear tunnel cross-piece
→ General body repairs, exterior; ...
© 2016-2026 Copyright www.vwgolf.org
Overview of fitting locations - front control motors, Climatronic, LHD
vehicles
Removing and installing temperature flap control motor -V68-, LHD vehicles