Volkswagen Golf Service & Repair Manual: Overview of fitting locations - front control motors, air conditioning system
with electric/manual controls, RHD vehicles
1 - |
Temperature flap control motor -V68- |
Checking: with vehicle diagnostic tester |
Removing and installing
→ Chapter. |
Renewing: initiate basic setting using vehicle diagnostic tester. |
2 - |
Air distribution flap control motor -V428- |
Checking: with vehicle diagnostic tester |
Removing and installing
→ Chapter. |
Renewing: initiate basic setting using vehicle diagnostic tester. |
3 - |
Air recirculation flap control motor -V113- |
Checking: with vehicle diagnostic tester |
Removing and installing
→ Chapter. |
Renewing: initiate basic setting using vehicle diagnostic tester. |
1 -
Temperature flap control motor -V68-
With potentiometer for temperature flap control motor -G92-.
Checking: with vehicle diagnostic tes ...
In vehicles with start-stop system, note abort conditions:
→ Chapter
1 -
Left temperature flap ...
Other materials:
Assembly overview - wheel bearing assembly, torsion beam axle
1 -
Dust cap
Renew after removing
Pressing off and driving in
→ Chapter
A proper seal can be achieved only by installing a new dust cap.
2 -
Bolt
Renew after remov ...
Test after driving for 10 minutes
First read and observe the introductory information
and safety warningsReconnect the tyre filler hose and check the tyre pressure
on the tyre pressure display ⑥.
1.3 bar (19 psi / 130 kPa) and lower:
Do not drive on! The tyre cannot be sealed adequately with
the breakdown set.
...
Assembly overview - drive shaft, triple roller joint AAR3300i
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
© 2016-2024 Copyright www.vwgolf.org