VW Golf manuals

Volkswagen Golf Service & Repair Manual: Overview of fitting locations - components not located in passenger compartment, Golf Variant RHD

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Overview of fitting locations - air conditioning system / Overview of fitting locations - components not located in passenger compartment, Golf Variant RHD

Overview of fitting locations - components not located in passenger compartment, Golf Variant RHD

1 -  Exhaust ventilation for passenger compartment
Checking → Chapter
Removing and installing → Chapter
2 -  Humidity sender for air conditioning system -G260-
Check via onboard supply control unit -J519-vehicle diagnostic tester in “Guided fault finding” mode and → Current flow diagrams, Electrical fault finding and Fitting locations
Removing and installing → Chapter
3 -  Fresh air intake
Removing and installing → Chapter
4 -  Air quality sensor -G238-
Check using vehicle diagnostic tester in “Guided fault finding” mode and → Current flow diagrams, Electrical fault finding and Fitting locations
Removing and installing → Chapter
Principles of operation → Chapter
Only on vehicles with Climatronic.
5 -  Cover for fresh air intake duct
Removing and installing → Chapter
6 -  Expansion valve
Removing and installing → Chapter
Specified torques → Chapter
7 -  Desiccant bag
Removing and installing → Chapter
Assembly overview → Chapter
8 -  Ambient temperature sensor -G17-
Check via onboard supply control unit -J519-vehicle diagnostic tester in “Guided fault finding” mode and → Current flow diagrams, Electrical fault finding and Fitting locations
Removing and installing → Chapter
9 -  Condenser
With integrated receiver
Assembly overview → Chapter
Removing and installing → Chapter
  Note
Under certain conditions, it is not necessary to renew the receiver with desiccant bag every time that the refrigerant circuit is opened. Refer to ELSA under Heating, ventilation, air conditioning system; Air conditioning system with refrigerant R134a → Air conditioning system with refrigerant R134a; Rep. gr.00.
10 -  Air conditioner compressor
Assembly overview → Chapter
Removing and installing → Chapter
Removing from and installing on bracket → Chapter
11 -  Evacuating and charging valve, high-pressure side
Removing and installing → Chapter
12 -  Pressure sender for refrigerant circuit -G805-
8 Nm
Checking: Use vehicle diagnostic tester in “Guided fault finding” mode and → Current flow diagrams, Electrical fault finding and Fitting locations
Removing and installing → Chapter
13 -  Evacuating and charging valve, low-pressure side
Removing and installing → Chapter
14 -  Refrigerant line with internal heat exchanger
From condenser and air conditioner compressor
Removing and installing → Chapter
Overview of fitting locations - components not located in passenger compartment, Golf Variant LHD
1 -  Exhaust ventilation for passenger compartment Checking → Chapter Removing and installing → Chapter ...

Overview of fitting locations - components located in front section of passenger compartment
...

Other materials:

Removing and installing brake system pressure accumulator -VX70-, LHD vehicles
Special tools and workshop equipment required     Torque wrench -V.A.G 1331-   Torque wrench -V.A.G 1410- ...

2-pack spray filler
Designation:   2-pack spray filler -ALN 788 007- Issued 06/2011 Product description The 2-pack spray filler -ALN 788 007- is a two-pack spray filler use in vehicle repai ...

Assembly overview - speed sensor on rear axle, front-wheel drive
1 -  ABS speed sensor Clean inside surface of hole before inserting sensor Coat inside surface with high-temperature paste -G 052 112 A3- Removing and installing → Chapter 2 -  Bolt ...

© 2016-2024 Copyright www.vwgolf.org