Volkswagen Golf Service & Repair Manual: Overview of fitting locations - components inside of front passenger compartment, LHD vehicles
| 1 - | Footwell vent on driver side |
| Removing and installing → Chapter |
| Assembly overview → Chapter. |
| 2 - | Temperature flap control motor -V68- |
| Removing and installing → Chapter |
| 3 - | Air distribution flap control motor -V428- |
| Removing and installing → Chapter |
| 4 - | Dust and pollen filter |
| Removing and installing → Chapter |
| 5 - | Air recirculation flap control motor -V113- |
| Removing and installing → Chapter |
| 6 - | Fresh air blower -V2- |
| Removing and installing → Chapter |
| 7 - | Footwell vent on front passenger side |
| Removing and installing → Chapter |
| Assembly overview → Chapter. |
| 8 - | Auxiliary air heater element -Z35- with auxiliary air heater control unit -J604- |
| Checking → Chapter |
| Removing and installing → Chapter |
| 9 - | Heat exchanger |
| Removing and installing → Chapter |
| 10 - | Operating and display unit |
| Removing and installing → Chapter |
Overview of fitting locations - components not located in passenger
compartment, Golf Variant RHD
1 -
Exhaust ventilation for passenger compartment
Checking
→ Chapter
Removing and installing
→ Chapter
...
Overview of fitting locations - components inside of front passenger
compartment, RHD vehicles
1 -
Air recirculation flap control motor -V113-
Removing and installing
→ Chapter
2 -
Dust and pollen filter
...
Other materials:
Detaching fibre optic cable from cable harness connector
Removing
–
Pull fibre optic cable connector off the relevant control
unit.
–
Release the locking mechanism in fibre optic cable connector
-1- by pressing it.
–
...
Overview of fitting locations – controls in rear doors
1 -
Rear driver side window regulator button -E711-
Removing and installing
→ Chapter
2 -
Rear passenger side window regulator button -E713-
Removing and installing
→ Chapter
...
Bringing air conditioning system into service after charging
Note
If the air conditioner compressor was removed, the V-belt
pulley /freewheel must be turned by hand approx. 10 times prior
to initial operation. This prevents any damage occurring from a
fluid hammer in the air conditioner compressor when th ...
