Volkswagen Golf Service & Repair Manual: Overview of fitting locations - auxiliary heater components, Golf Variant
1 - |
Auxiliary heater aerial -R182- |
For vehicles with auxiliary heater and remote control. |
Removing and installing auxiliary heater aerial -R182-
→ Communication; Rep. gr.91. |
2 - |
Ambient temperature sensor -G17- |
Checking: with vehicle diagnostic tester |
Removing and installing
→ Chapter |
3 - |
Exhaust system of auxiliary heater |
Removing and installing
→ Chapter |
4 - |
Circulation pump -V55- |
Fitting location: on auxiliary/supplementary heater |
Removing and installing
→ Chapter |
With auxiliary heater control unit -J364-. |
Location: behind front bumper cover on right |
Removing and installing
→ Chapter |
With fuel gauge sender -G- |
Removing and installing
→ Rep. gr.20 |
Check fuel supply to auxiliary heater
→ Chapter. |
The metering pump -V54- might tick audibly but fail to deliver fuel
because there is air in the suction hose. The control unit will then
switch off permanently. Read event memory using vehicle diagnostic
tester, auxiliary heater self-diagnosis. Erase event memory and perform
final control diagnosis for auxiliary heater. |
Removing and installing
→ Chapter |
Testing quantity of fuel delivered
→ Chapter |
8 - |
Remote control receiver for auxiliary coolant heater -R149- |
Removing and installing
→ Chapter |
Note
The illustration shows a Golf.
1 -
Auxiliary heater aerial -R182-
For veh ...
Other materials:
Preparing body flange for fitting
WARNING
Keep bonding surface free of dirt and grease.
Do not treat bonding surface with activator
immediately after cutting back. Do not prime. Do not
treat with cleaning solution.
...
Crimping pliers -VAS 1978/1A
Crimping pliers -VAS 1978/1A- or crimping pliers (base tool)
-VAS 1978/1-2- together with head adapter 0.35 - 2.5 mmІ -VAS
1978/1-1- or head adapter 4.0 - 6.0 mmІ -VAS 1978/2A- are used
to squeeze together crimp connectors from ...
Removing and installing tyre pressure sensor, metal valve body
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410- and 11 mm insert
tool-V.A.G 1331-.
–
Push metal valve with rubber seal t ...
© 2016-2024 Copyright www.vwgolf.org