Volkswagen Golf Service & Repair Manual: Overview of fitting locations - auxiliary heater components, Golf and Golf
GTE
Note
The illustration shows a Golf. |
|
|
|
1 - |
Auxiliary heater aerial -R182- |
For vehicles with auxiliary heater and remote control. |
Removing and installing auxiliary heater aerial -R182-
→ Communication; Rep. gr.91. |
2 - |
Ambient temperature sensor -G17- |
Checking: with vehicle diagnostic tester |
Removing and installing
→ Chapter |
3 - |
Exhaust system of auxiliary heater |
Removing and installing
→ Chapter |
4 - |
Circulation pump -V55- |
Fitting location: on auxiliary heater. |
Removing and installing
→ Chapter |
With auxiliary heater control unit -J364-. |
Location: behind front bumper cover on right |
Removing and installing
→ Chapter |
With fuel gauge sender -G- |
Removing and installing
→ Rep. gr.20 |
Check fuel supply to auxiliary heater
→ Chapter. |
The metering pump -V54- might tick audibly but fail to deliver fuel
because there is air in the suction hose. The control unit will then
switch off permanently. Read event memory using vehicle diagnostic
tester, auxiliary heater self-diagnosis. Erase event memory and perform
final control diagnosis for auxiliary heater. |
Removing and installing
→ Chapter |
Testing quantity of fuel delivered
→ Chapter |
8 - |
Remote control receiver for auxiliary coolant heater -R149- |
Removing and installing
→ Chapter |
1 -
Auxiliary heater aerial -R182-
For vehicles with auxiliary heater and remote control.
Removing and installing auxiliary heater aerial - ...
Other materials:
Undercoated areas
Note
Undercoating (stone-chipping protection) applied during repair work
must be identical in appearance and thickness to the original
undercoating.
Water drainage holes must remain clear.
All threaded studs and welded nuts with metric ...
2-pack HS Performance surfacer
Designation:
2-pack HS Performance surfacer -LVM 014 100 A4-, white
2-pack HS Performance surfacer -LVM 014 173 A4-, dark grey
2-pack HS Performance surfacer -LVM 014 190 ...
Dimensions - lettering on rear lid, “GTI/GTD”
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
Height dimension
75.5 ± 1 mm, from lower edge of lettering to tail light.
...
© 2016-2024 Copyright www.vwgolf.org