Volkswagen Golf Service & Repair Manual: Overview of fitting locations

Volkswagen Golf Service & Repair Manual / Brake system (hybrid) / ABS, ADR, TCS, EDL, ESP / Overview of fitting locations

Overview of fitting locations - ABS/ESP

Overview of fitting locations

1 -	ABS control unit -J104-

Installation location: on hydraulic unit, on passenger side of engine compartment.

Do not separate connector before successfully completing self-diagnosis. Switch ignition off before separating connector.

The following components are integrated into the control unit:

Control unit for electromechanical parking brake -J540-

Lateral acceleration sender -G200-

Yaw rate sender -G202-

Longitudinal acceleration sender -G251- (depending on equipment fitted)

The components cannot be renewed individually.

Assembly overview → Chapter.

Removing and installing → Chapter

2 -	ABS hydraulic unit -N55-

Fitting location: on passenger side of engine compartment

The hydraulic unit consists of the components:

ABS hydraulic pump -V64-

Brake pressure sender -G201-

Valve block (contains inlet and outlet valves).

ABS hydraulic pump -V64- and valve block must not be separated from one another.

Assembly overview → Chapter.

Removing and installing → Chapter

3 -	Brake pad warning lamp -K32-

Location: in dash panel insert.

4 -	ABS warning lamp -K47-

Location: in dash panel insert.

5 -	ESP and TCS warning lamp -K155-

Location: in dash panel insert.

6 -	Brake system warning lamp -K118-

Location: in dash panel insert.

7 -	Diagnostic connection

Location: Driver footwell cover.

8 -	Steering angle sender -G85-

Fitting location: in steering rack.

The steering angle sender -G85- cannot be renewed separately.

Removing and installing steering → Running gear, axles, steering; Rep. gr.48.

9 -	Wheel hub with wheel bearing

ABS sensor ring is installed in wheel bearing

10 -	Front right/left speed sensor -G45-/-G47-

Removing and installing → Chapter.

11 -	Wheel hub with wheel bearing

ABS sensor ring is installed in wheel bearing

12 -	Rear right/left speed sensor -G44-/-G46-

Removing and installing → Chapter

13 -	Brake servo

Assembly overview → Chapter.

Removing and installing → Chapter

14 -	TCS and ESP button -E256-

Two versions, therefore two fitting locations:

Button in centre console

Function button in menu of infotainment system

Removing and installing TCS and ESP button -E256- in centre console → Electrical system; Rep. gr.96.

General information

Repair instructions for repair work on ABS The ABS brake system is divided diagonally. The servo-assistance is effected pneumatically by the vacuum b ...

Control unit and hydraulic unit

...

Other materials:

Assembly overview - flanging tool
1 - Flanging tool upper part Unbolt to change flanging jaws 2 - Fastening for handle Must be unscrewed to access securing bolt for upper part. 3 - Securing bolt For fla ...

Silicone remover
Designation: Aqueous silicone remover -LSW 019 000 A5- Silicone remover -LVM 020 000 A5- Slow-drying silicone remover -LVM 020 100 A5- Issued 02.2012 ...

Battery
Battery - general notes Note All instructions and notes regarding this chapter are available under → Electrical System, General Information; Rep. gr.27. ...