Volkswagen Golf Service & Repair Manual: Other controlling and regulating components
- Removing and installing sunlight penetration photosensor -G107-
- Function of air quality sensor -G238-
- Removing and installing ambient temperature sensor -G17-
- Removing and installing humidity sender for air conditioning system -G260-
- Removing and installing left vent temperature sender -G150
- Removing and installing right vent temperature sender -G151
- Removing and installing footwell vent temperature sender -G192
Removing and installing operating and display unit, air conditioning system
with electric/manual controls and Climatronic
Special tools and workshop equipment
required
Removal wedge -3409-
Note
...
Removing and installing sunlight penetration photosensor -G107-
Special tools and workshop equipment
required
Removal wedge -3409-
Removing
...
Other materials:
Removing and installing alternator, vehicles with 1.2 l TSI engine, 1.4 l
TSI engine and 1.4 l TSI natural gas engine
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removing
–
With ignition switched off, disconnect earth cable from
...
Removing and installing side spoiler
Removing
Special tools and workshop equipment
required
Hot air blower -V.A.G 1416
Note
Only the left side is shown. The right si ...
Removing and installing front air distribution flap control motor -V426-,
LHD vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...
