Volkswagen Golf Service & Repair Manual: Oil seals

Final drive, differential, differential lock

...

Overview of fitting locations - seals

1 -  Left flange shaft 2 -  Bolt Always renew after removing. 30 Nm 3 -  Seal, left ...

Other materials:

Assembly overview - short noise insulation
  Note The removal and installation procedures may have to be modified slightly depending on engine fitted. 1 -  Short noise insulation Removing –  Remove bolts -2- and -3- –  Pull out noise ...

Removing and installing striker pin
Special tools and workshop equipment required         Torque wrench -V.A.G 1331- Removing –  Remove trim for rear lid lock → General bod ...

Removing and installing emblems at rear
  Note The emblem cannot be removed without damage. Removing –  Use a screwdriver -3- to carefully lever manufacturer emblem -1- off swivel badge -2- in -direction of arrow A-. Installing –  Pres ...