Volkswagen Golf Service & Repair Manual: Nuts and bolts

Volkswagen Golf Service & Repair Manual / 7- speed dual clutch gearbox 0CW / Technical data / Repair instructions / Nuts and bolts

Loosen and tighten securing bolts and securing nut for covers and housings diagonally.

Specified torques settings are specified for unoiled bolts and nuts.

Threads of bolts secured with locking fluid must be cleaned with a wire brush. Then insert bolts with locking fluid -AMV 185 101 A1-.

Threaded holes into which self-locking bolts or bolts coated with locking fluid are screwed, must be cleaned (e.g. with a thread chaser). Otherwise there is a danger of bolts shearing when subsequently being removed.

Always renew self-locking bolts and nuts.

Nuts and bolts

Gaskets, seals

After removing gaskets and seals, always inspect contact surface of housing or shaft for burrs resulting from removal or for other signs of damage. ...

Technical data

Allocation gearbox - engine Golf 2013 ►, Golf Estate 2014 ► Always take account of the gearbox code if ...

Other materials:

Exploded view - mechatronic unit
1 - Bolt For securing mechatronic unit for dual clutch gearbox -J743- on gearbox housing. Qty 3, M8 x 35 Always renew after removing. Specified torque and tightening sequence → Fig. ...

Removing and installing actuator
Removing – Removing radiator grille → Chapter – Remove bolts -2-. – Remove actuator -1-. Installing ...

Removing and installing number plate light -X4-/-X5-
Note If an LED number plate light is faulty, the entire number plate light must be renewed. Removing – Turn light switch to “0” position. ...