Volkswagen Golf Service & Repair Manual: Notes for vehicles with start-stop system

Volkswagen Golf Service & Repair Manual / Auxiliary heater / Technical data / General notes / Notes for vehicles with start-stop system

Observe the safety precautions for vehicles with a Start/Stop system → Chapter.

The following abort conditions deactivate the start-stop-function:

The Start/Stop system has been switched off via the start-stop mode button.

The charge status of the battery -A- is insufficient to restart the engine (starting voltage prediction).

The defrost function is active.

The windscreen heater function is active.

The temperature set on the operating and display unit varies by more than 8°C from the actual interior temperature.

The engine speed is greater than 1200 rpm.

The alternator -C- is defective, i.e. belt broken.

Coolant temperature is not within specifications of 25 °C - 100 °C.

Blower speed increase by more than 4 stages.

Refer to → No.426 for full description.

Starting conditions for auxiliary heater, supplementary heater mode

Terminal 15 (ignition) on Engine speed > 600 rpm Coolant temperature < 72 °C Ambient ...

Rules for cleanliness for working on the auxiliary heater and the fuel system

Thoroughly clean all connections and adjacent areas before disconnecting. Place parts that have been removed on a clean surface and cover ...

Other materials:

Removing and installing condenser
Special tools and workshop equipment required Torque wrench -V.A.G 1331/- (5…50 Nm) Air conditioner service station Note The pre ...

Balancing wheel, balancing wheel with finish balancer
Before you start balancing the wheels, the following requirements must be met. Tyre pressure must be OK. Tread must not be worn on one side. Tread depth should be at least 4 mm. T ...

Removing and installing humidity sender for air conditioning system -G260-
The humidity sender for air conditioning system -G260- and the light/rain sensor -G397- form one component and are installed depending on vehicle equipment. – Removal and installation procedure is described in → E ...