Volkswagen Golf Service & Repair Manual: Moving mechatronic unit for dual clutch gearbox -J743- into removal position
by hand
Note
Only if you cannot set the mechatronic unit to removal position with
the vehicle diagnostic tester, you must set the unit by hand to removal
position. |
Sometimes, the mechatronic unit cannot be removed. In this case, the
gear actuator for 6th gear/ reverse gear is
»caught« at the »top left« of the
gearbox housing -arrow-. |
The »sticking« gear actuator must now be
pressed by hand into a »removal position«.
The cover on the selector shaft must be removed for this. |
– |
Reinsert mechatronic unit completely into gearbox and secure it with
a bolt. |
– |
Move selector lever to “P” position. |
|
|
|
– |
Remove cover for parking lock -1-
→ Chapter. |
Caution
Risk of causing permanent damage by mechatronic unit
falling out. |
After the next work step, the mechatronic unit is
free and could fall out. If it has not already been
done, secure mechatronic unit on gearbox with 1 bolt to
prevent it from falling down. |
|
|
|
|
– |
Working through opening, push selector fork for 6th
gear/ reverse gear towards side -arrow-. |
|
|
|
This presses back the »sticking«
gear actuator -arrow- and the
mechatronic unit can be removed. |
– |
Remove mechatronic unit. |
|
|
|
– |
After work on mechatronic unit has been completed and
mechatronic unit has been installed, fill up with gear oil via
parking lock
→ Chapter. |
– |
Install cover for parking lock -1-
→ Chapter. |
|
|
|
Special tools and workshop equipment
required
Vehicle diagnostic tester
Us ...
Assembly overview - selector mechanism ...
Other materials:
Sealing and inflating tyres
First read and observe the introductory information
and safety warningsSealing a tyre
Unscrew the cap from the tyre valve.
Use the valve core extractor to screw the valve core out of the tyre valve.
Place the core on a clean surface.
Shake the tyre filler bottle vigorously up a ...
An economic driving style
First read and observe the introductory information
and safety warnings Changing gear earlier
In principle, the highest gear is always the most economical gear. A rule of
thumb for most vehicles: at a speed of 30 km/h (18 mph) drive in 3rd gear, at 40
km/h (25 mph) in 4th gear and at 50 km/ ...
Assembly overview - windscreen wiper system
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Wiper blade on driver side
Different lengths. Refer to
→ Electronic Parts Catalogue.
...
© 2016-2024 Copyright www.vwgolf.org