Volkswagen Golf Owners Manual: Mechanical controls on the front seat
Fig. 43 Front left-hand seat controls
First read and observe the introductory information
and safety warnings The layout of the controls on the front right-hand seat is a mirror image of the layout of the controls on the front left-hand seat.
The following section contains a description of all possible controls. The number of controls may vary depending on the version of the seat.
The seat may have a combination of mechanical and electrical controls .
| Function | Action | |
|---|---|---|
| ① | Folding the seat backrest forwards or backwards (2-door vehicles only) | Folding forwards: Pull lever and fold seat backrest forward. Push the seat forwards at the same time. |
| Folding backwards: slide the seat back as far as it will go until it clicks into place. The backrest releases automatically and can be folded backwards. Engage the seat backrest in an upright position. | ||
| ② | Adjusting the lumbar support. | Change lever position. |
| ③ | Adjusting the backrest. | Take all weight off the backrest and turn the handwheel. |
| ④ | Adjusting the seat height. | Move the lever up or down several times as required. |
| ⑤ | Adjusts the angle of the seat cushion. | Pull or press the lever several times as required. |
| ⑥ | Adjusts the seat forwards and backwards. | Raise the handle and slide the seat forwards or backwards. |
| ⑦ | Pushing the front seat forwards or backwards. | Lift the handle and move the front seat. The front seat must engage after the lever has been released. |
Correct sitting position
Fig. 41 There must be a distance of at
least 25 cm between the driver and the steering wheel The distance to the dash panel
must be at least 10 cm in the knee area
Fig. 42 Correct seat belt rout ...
Electrical controls on the front seats
Fig. 44 Moving the front left seat forwards
and backwards, adjusting the backrest and the seat cushion for height and tilt
Fig. 45 Adjusting the lumbar support.
First read and observe the intr ...
Other materials:
Dimensions – “e-Golf” lettering on rear lid
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
Height dimension
75.5 ± 1 mm, from lower edge of lettering to tail light
3& ...
Repairing subframe
Special tools and workshop equipment required
Assembly tool -T10205-
Torque wrench -V.A.G 1332-
Hydraulic press -VAS 6178-
Foot pump -VAS 6179-
Assembly tool -VAS 6779-
...
Removing and installing speed sensor on rear axle -G44-/-G46-, vehicles with
front-wheel drive
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
Rear left speed sensor -G46--1-:
...
