Volkswagen Golf Service & Repair Manual: Measuring axial clearance of crankshaft
Risk of damage to bearing pedestals when the
crankshaft is removed.If the bolts of the crankshaft bearing cap are
loosened, the bearing pedestals of the cylinder block will be deformed,
and damage to the bearings will result.Never remove the crankshaft.
Special tools and workshop equipment
required |
|
|
|
Universal dial gauge bracket -VW 387- |
|
|
|
– |
Screw dial gauge -VAS 6079- with universal dial gauge
bracket -VW 387- to cylinder block as shown in the illustration. |
– |
Position dial gauge against crank web. |
– |
Press crankshaft against dial gauge by hand and set gauge to
“0”. |
– |
Push crankshaft away from dial gauge and read off measured
value. |
Axial clearance: 0.066 … 0.233 mm. |
|
|
|
Risk of damage to bearing pedestals when the
crankshaft is removed.If the bolts of the crankshaft bearing cap are
loosened, the bearing pedestals of the cylinder block will be deformed, ...
Other materials:
Removing and installing manufacturer emblem
Note
The emblem cannot be removed without damage.
Removing
–
Use a screwdriver -3- to carefully
lever manufacturer emblem -1- out of
radiator grille -2- in
-direction of arrow A-.
Installing
–
...
Introduction
This chapter contains information on the following subjects:
→ Vehicle identification data
→ Engine data
→ Dimensions
→ Performance figures
The vehicle data sticker in the service schedule or the vehicle registration
documents show which engin ...
Assembly overview - tail lights in vehicle body, with bulbs
1 -
Left tail light -MX3-/right tail light -MX4-
Tail light in body
Removing and installing
→ Chapter
2 -
Brake and tail light bulb
Left brake and tail light bulb -M21-
...
© 2016-2024 Copyright www.vwgolf.org