
Fig. 134 Gear shift pattern of a 5-speed manual gearbox

Fig. 135 Gear shift pattern of a 6-speed manual gearbox
First read and observe the introductory information
and safety warnings The positions of the individual driving gears are shown on the gearshift lever or .
In some countries, the clutch pedal will have to be depressed fully in order to start the engine.
Selecting reverse gear
Shifting down
You should always select the next immediate gear when shifting down a gear whilst the vehicle is in motion. The engine revs should not be too high when doing this . Damage to the clutch and the gearbox can occur if one or more gears are skipped when shifting down a gear at high speeds or high engine revs, even if the clutch is not released in the process .
Kickdown
In vehicles with a speed limiter , the kickdown function allows the driver to intentionally exceed the stored regulated speed, e.g. when overtaking.
When the accelerator is fully depressed, the speed limiter regulator is temporarily switched off when the vehicle exceeds the stored speed.
Once the vehicle returns to a speed below the stored speed and the accelerator is no longer fully depressed, speed limiter regulation becomes active again.

WARNING

WARNING

NOTICESerious damage to the clutch and gearbox can occur if the gear stick on the manual gearbox is shifted to too low a gear when travelling at high speeds or at high revs. This also applies if the clutch remains depressed and the gears do not engage.

NOTICE
Pedals
Automatic gearbox: selecting a gearVibration control system
Using the vibration control system -VAS 6230 A- you can
perform more functions than just stationary balancing.
A special feature of this system is the testing of the
radial force of the wheel and tyre while rolling.
A ro ...
Incorporation of high-voltage heater (PTC) - Z115- into coolant circuit
Note
In vehicles with a high-voltage system, the high-voltage
heater (PTC) -Z115- is used as a supplementary heater.
In vehicles with a high-voltage system and an auxiliary
heater installed as optional equipment, the ...
Removing and installing voltage regulator, manufacturer: Valeo
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removing
–
Remove alternator -C-
→ Chapter.
...