Volkswagen Golf Service & Repair Manual: Lowering rear axle, multi-link suspension, front-wheel drive, except for
e-Golf
Special tools and workshop equipment required |
Torque wrench -V.A.G 1332- |
Engine and gearbox jack -V.A.G 1383 A- |
Lower subframe with attachments. |
– |
Unbolt brake calipers on both sides of vehicle and suspend
from body. |
– |
Remove springs
→ Chapter. |
– |
Remove rear silencer of exhaust system
→ Rep. gr.26. |
Vehicles with vehicle level sender |
|
|
|
– |
Disconnect connector -1-. |
Continuation for all vehicles |
|
|
|
– |
Unplug electrical connector -1-
from ABS speed sensor on both sides and move clear. |
– |
Unplug electrical connector -2-
from electromechanical parking brake motor on brake caliper on
both sides. |
– |
Detach electrical wiring harness from retainers
-arrows- and move clear. |
|
|
|
– |
Pull out retaining clip -1- on
both sides of vehicle. |
– |
Free brake lines from holder. |
Note
|
|
|
– |
Use tensioning straps -T10038--1-
to strap vehicle to support beams of lifting platform on both
sides. |
WARNING
If the vehicle is not strapped down, there is a
great danger that the vehicle will slip off the lifting
platform! |
|
– |
Fix subframe at both forward bolts
→ Chapter. |
|
|
|
– |
Unscrew rear right bolt of subframe
-arrow-. |
|
|
|
– |
Screw spindle -3346/2- into thread of longitudinal member
using thrust piece of assembly tool -3301- and nut -3346/3-. |
3 - |
Thrust piece from assembly tool -3301- |
– |
Unscrew rear left bolt of subframe. |
– |
Turn nut -3346/3- on spindle -3346/2- until subframe is
lowered by -a- = 40 mm. |
Installing subframe with attachments |
Install in reverse order of removal, observing the
following: |
→ Chapter „Torque settings for wheel bolts“ |
Exhaust pipes double clamp
→ Rep. gr.26. |
On vehicles with vehicle level sender, carry out basic
settings for wheel damper electronics → Vehicle
diagnostic tester. |
On vehicles with vehicle level sender, carry out basic
adjustment of headlights
→ Electrical system; Rep. gr.94. |
– |
When does wheel alignment have to be checked
→ Chapter? |
|
|
|
I -
→ Chapter „Subframe“
II -
→ Chapter „Anti-roll bar“
III -
→ Chapter „Sus ...
Special tools and workshop equipment required
Assembly tool -3301-
Assembly tool -3346-
Torque wrench -V.A.G 1332-
...
Other materials:
Information stickers and plates
First read and observe the introductory information
and safety warnings Safety certificates, stickers and plates showing important
vehicle operation information are factory-fitted in the engine compartment and on
certain parts such as the tank flap, front passenger sun visor, the driver door ...
Removing and installing rear window regulator switch in door -E52-/-E54-
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way (mirror image of left side).
–
Remove rear door trim
→ Gene ...
Adjusting striker pin
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Socket -3410-
Note
Threaded ...
© 2016-2024 Copyright www.vwgolf.org