Volkswagen Golf Service & Repair Manual: Lowering rear axle, multi-link suspension, four-wheel drive
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1332- |
|
|
|
Engine and gearbox jack -V.A.G 1383 A- |
Lower subframe with attachments. |
– |
Unbolt brake calipers on both sides of vehicle and suspend
from body. |
– |
Remove springs
→ Chapter. |
– |
Remove rear silencer of exhaust system
→ Rep. gr.26. |
Vehicles with vehicle level sender |
|
|
|
– |
Disconnect connector -1- from
vehicle level sender -2-. |
Continuation for all vehicles |
|
|
|
– |
Unplug electrical connector -1-
from ABS speed sensor on both sides and move clear. |
– |
Unplug electrical connector -2-
from electromechanical parking brake motor on brake caliper on
both sides. |
– |
Detach electrical wiring harness from retainers
-arrows- and move clear. |
|
|
|
– |
Pull out retaining clip -1- on
both sides of vehicle. |
– |
Free brake lines from holder. |
Note
– |
Disconnect propshaft from rear final drive, and secure it
→ Rep. gr.39. |
|
|
|
– |
Use tensioning straps -T10038--1-
to strap vehicle to support beams of lifting platform on both
sides. |
WARNING
If the vehicle is not strapped down, there is a
great danger that the vehicle will slip off the lifting
platform! |
|
– |
Fix position of subframe
→ Chapter. |
– |
Carefully lower subframe with attachments about 20 mm. |
– |
Disconnect connector on Haldex coupling above final drive. |
|
|
|
– |
Unclip brake line -1- from clip
-arrow- on left side. |
Note
The clip will be destroyed and must be renewed. |
– |
Lower subframe with attachments about 140 mm. |
Installing subframe with attachments |
Install in reverse order of removal, observing the
following: |
→ Chapter „Assembly overview - subframe, multi-link suspension,
four-wheel drive“ |
→ Chapter „Torque settings for wheel bolts“ |
Exhaust pipes double clamp
→ Rep. gr.26. |
On vehicles with vehicle level sender, carry out basic
settings for wheel damper electronics → Vehicle
diagnostic tester. |
On vehicles with vehicle level sender, carry out basic
adjustment of headlights
→ Electrical system; Rep. gr.94. |
– |
When does wheel alignment have to be checked
→ Chapter? |
|
|
|
Special tools and workshop equipment required
Assembly tool -3301-
Assembly tool -3346-
Torque wrench -V.A.G 1332-
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
...
Other materials:
Removing and installing rear left vehicle level sender -G76-, torsion beam
axle
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Disconnect co ...
Reinforced and Extra Load (XL) tyres
Some tyre manufacturers have for some time replaced the
designation “Reinforced” with the designation “Extra Load”. This
designation has long been standard in non-European countries.
Technically, there is no difference between them.
...
Vapour pressure
In an enclosed container that is not completely full,
refrigerant evaporates as vapour at the surface in a quantity
sufficient to form an equilibrium between vapour and liquid.
This equilibrium develops under pressure and is often called
vapour pressure. ...
© 2016-2024 Copyright www.vwgolf.org