Volkswagen Golf Service & Repair Manual: Loosening and tightening threaded connections of drive shaft
Special tools and workshop equipment
required |
|
|
|
Angle wrench -V.A.G 1756 A- |
Caution
Wheel bearings must not be subjected to load after
bolt securing drive shaft to wheel hub has been
loosened. |
If wheel bearings are loaded with weight of vehicle,
bearing will be damaged. This reduces the service life
of the wheel bearing. |
It is not permissible to loosen drive shaft bolt
more than 90° if vehicle is standing on its wheels. |
Do not attempt to move the vehicle without the drive
shafts fitted as this would damage the wheel bearing. If
a vehicle nevertheless has to be moved, comply with the
following: |
Install an outer joint instead of the drive shaft. |
Tighten outer joint to 120 Nm. |
|
Loosen outer bolt on drive shaft. |
– |
To avoid damage to wheel bearing, do not loosen bolt using
24 mm socket -T10361A- further than 90° with vehicle still
standing on its wheels. |
– |
Raise vehicle so that wheels are off the ground. |
– |
Have second mechanic apply brakes. |
|
|
|
Tighten outer bolt on drive shaft. |
– |
Renew outer bolt for drive shaft. |
Note
It must be ensured that the wheels do not yet touch the
floor when the drive shaft is being tightened. Otherwise the
wheel bearing may be damaged. |
– |
Have second mechanic apply brakes. |
– |
Tighten bolt to 200 Nm. |
– |
Lower vehicle onto its wheels. |
– |
Turn bolt 180° further. |
|
|
|
Special tools and workshop equipment required
Thrust plate -VW 401-
Thrust plate -VW 402-
Press tool -VW 408 A-
Press t ...
The joint is to be dismantled to renew the grease if it is
heavily soiled, or to check the running surfaces of the balls
for wear and damage.
R ...
Other materials:
Removing and installing control unit and hydraulic unit, RHD vehicles
Special tools and workshop equipment required
Torque wrench -V.A.G 1331-
Torque wrench -V.A.G 1410-
Brake pedal depressor -V.A.G 1869/2-
Sealing plugs, assemb ...
Tyre pressure monitor
System description – Tyre Pressure Monitoring System
General notes:
The tyre pressure monitor display system is part of the
software in the ABS control unit -J104-. The system is used to
detect slow tyre pressure loss from a wheel. Event me ...
1-pack wash primer
Designation:
1-pack wash primer -LVM 044 007 A2-, light grey
1-pack wash primer -LVM 044 171 A2-, dark grey
Issued 08.2013
Product description
...
© 2016-2024 Copyright www.vwgolf.org