This chapter contains information on the following subjects:
→ Running-in
→ Accessories and parts→ Service fluids and consumables
→ Repairs and technical modifications→ Repairs and faults in the airbag system
→ Retrofitting two-way radios→ Information stored in the control units
→ Using a mobile telephone in the vehicle without a connection to the external aerial→ Vehicle lifting points
→ Rodent proofingAdditional information and warnings:

WARNING
Running-inCalibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
  ...
Rodent proofing
First read and observe the introductory information
and safety warnings Rodent proofing equipment is made up of special brushes
and casings and impedes entry to the engine compartment by rodents when the bonnet
is shut. This prevents damage caused to components by rodent bites.
NOTICE
If ...
Vehicles with torsion beam axle
Removing
–
If fitted, remove rear left underbody trim
→ General body repairs, exterior; Rep. gr.66.
–
Remove rear tunnel cross-piece
→ General body repairs, exterior; ...