This chapter contains information on the following subjects:
→ Display and warning and indicator lamp
→ Operating the speed limiterThe speed limiter helps the driver not to exceed an individual stored speed when driving forwards at speeds of approximately 30 km/h (20 mph) and above .
Additional information and warnings:

WARNING
Speed limiter
Display and warning and indicator lampRemoving and installing front airbag crash sensor, driver side -G283-
Removing
WARNING
Observe safety instructions for pyrotechnic
components
→ Chapter.
Risk of injury due to automatic engine starting in
vehic ...
Removing and installing shock absorber, torsion beam axle
Special tools and workshop equipment required
Torque wrench -V.A.G 1332-
Torque wrench -V.A.G 1410-
Spring compressor -V.A.G 1752/1-
Spring retainer -V.A.G 1752/3A-
Removing
...
Test prerequisites
Radiator and condenser must be clean (clean them if
necessary).
The heat insulation on expansion valve is OK and properly
installed. See vehicle-specific repair manual
→ Rep. gr.87.
The poly V ...