VW Golf manuals

Volkswagen Golf Owners Manual: Introduction

This chapter contains information on the following subjects:

 → Indicator lamps  

 → Turn signal and main beam lever  

 → Switching lights on and off  

 → Lights and vision – functions  

 → Main beam assist  

 → Switching over headlights for driving abroad (travel mode)  

 → Coming Home and Leaving Home functions (orientation lighting)  

 → Headlight range control, instrument and switch lighting  

 → Interior and reading lights  

Observe any country-specific regulations when using vehicle lighting.

The driver is responsible for the correct headlight position and the correct headlight setting.

Additional information and warnings:

WARNING

Accidents and serious injuries can occur if roads are not sufficiently illuminated and other road users have difficulty seeing the vehicle, or cannot see it at all.

WARNING

Setting headlights too high, and the incorrect use of the main beam, could distract and dazzle other road users. This can lead to accidents and serious injuries.
Lights
...

Indicator lamps
First read and observe the introductory information and safety warnings  Lit up Possible cause Solution Partial or complete fault in ...

Other materials:

Connections to valves for switches in the refrigerant circuit
  WARNING Danger of freezing injuries. If refrigerant circuit has not been evacuated, refrigerant will escape. The refrigerant must be extracted before the va ...

Assembly overview - cylinder head
  Note The camshafts must not be removed individually. In the event of repair, the camshaft housing must be renewed completely.   Note The illustration shows the cylinder head for en ...

Assembly overview - toothed belt, engine codes CPTA, CHPA, CZEA, CZDA
1 -  Toothed belt Before removing, mark direction of rotation with chalk or felt-tipped marker pen. Check for wear Removing → Chapter Installing (adjusting valve timing), CPTA, CZEA & ...

© 2016-2026 Copyright www.vwgolf.org