Volkswagen Golf Service & Repair Manual: Installing roof reinforcement to body, estate without sliding sunroof

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Trim, noise insulation / Roof trims / Installing roof reinforcement to body, estate without sliding sunroof

Special tools and workshop equipment required

Electric cutter -V.A.G 1561A

Scraping blade -V.A.G 1561/20

Cartridge gun -V.A.G 1628

Release lever -T10039

Removing

–	Remove moulded headliner → Chapter.

–	Cut roof reinforcements -1- and -2- into approx. 6 cm wide strips -3--dot-dash lines-, using a cutter knife.

–	Pull strips -3- from roof.

–	Trim back adhesive residues with electric cutter -V.A.G 1561A- and scraping blade -V.A.G 1561/20-.

Note

If the paint structure has been damaged on removal of roof reinforcements, repair paint damage according to guidelines of → Paint workshop manual.

Installing

Note

Observe adhesive processing instructions when installing the roof reinforcement.

Installing roof reinforcement to body, estate without sliding sunroof

–	Use hand-cartridge gun -V.A.G 1628- to apply single-component assembly adhesive ( → Electronic Parts Catalogue) to roof reinforcements. Observe the following dimensions while doing so.

Dimension -a- = 35 mm
Dimension -b- = 31 mm
Dimension -c- = 58 mm

Installing roof reinforcement to body, estate without sliding sunroof

–	Measure roof reinforcements -1- and -2- to width and mark centre of both sides.

–	Guide roof reinforcement -1- into vehicle.

–	Position roof reinforcement -1- according to -dimension a- centrally on roof and press it on across entire surface.

Dimension -a- for saloon = 50.5 ± 3 mm from front sheet-metal edge.

Dimension -a- for estate without sliding sunroof = 25 ± 1 mm from front sheet-metal edge.

–	Guide roof reinforcement -2- into vehicle.

–	Position roof reinforcement -2- according to -dimension b- centrally on roof and press it on across entire surface.

Dimension -b- for saloon = 61 ± 3 mm from rear sheet-metal edge.

Dimension -b- for estate without sliding sunroof = 25 ± 1 mm from rear sheet-metal edge.

Installing roof reinforcement to body, estate without sliding sunroof

Removing and installing moulded headliner, estate

Special tools and workshop equipment required Removal lever -80 - 200 &nbs ...

Installing roof reinforcement to body, estate with sliding sunroof

Special tools and workshop equipment required Electric cutter -V.A.G 1561A ...

Other materials:

Removing and installing track rod ball joint
Special tools and workshop equipment required Ball joint puller -T10187- Torque wrench -V.A.G 1332- ...

Removing and installing speed sensors on front axle -G45-/-G47
Note Removal and installation is described for the front left speed sensor. Removal and installation of the front right speed sensor is analogous. Removing – Raise vehicle. &n ...

Removing and installing steering column switch module, Valeo
Removing – Move steering wheel to rearmost and lowest position. Use the entire range of adjustment of the steering column for this purpose. – Remove steering wheel → Running g ...