Volkswagen Golf Service & Repair Manual: Installing roof reinforcement to body, estate with sliding sunroof
Special tools and workshop equipment
required |
|
|
|
|
|
Electric cutter -V.A.G 1561A |
|
|
Scraping blade -V.A.G 1561/20 |
|
|
Cartridge gun -V.A.G 1628 |
|
|
Release lever -T10039 |
– |
Use hand-cartridge gun -V.A.G 1628- to apply
single-component assembly adhesive (
→ Electronic Parts Catalogue) to roof reinforcements.
Observe the following dimensions while doing so. |
|
|
|
– |
Measure roof reinforcements -1-
to width and mark centre of both sides. |
– |
Guide roof reinforcement -1-
into vehicle. |
– |
Position roof reinforcement -1-
according to -dimension a-
centrally on roof and press it on across entire surface. |
Dimension -a- = 12 ± 1 mm from
rear sheet-metal edge. |
|
|
|
Special tools and workshop equipment
required
Electric cutter -V.A.G 1561A
...
Other materials:
Blowing through refrigerant circuit with compressed air and nitrogen
Use compressed air to force moisture and other contaminants
out of the refrigerant circuit and use nitrogen to force
moisture out of the refrigerant circuit.
The method of blowing through the refrigerant circuit with
compressed air ...
Towing attachment type plate
The trailer load and drawbar load details on the type plate
of the towing attachment are test figures for the device. The
approved details for the relevant vehicle could be below the
trailer load and drawbar load specifications of the trailer.
Figures ca ...
Removing and installing suction-jet pump
On vehicles with four-wheel drive the fuel tank is divided
into a left and a right chamber. A suction-jet pump
-2- is used for delivering fuel
from the left fuel tank chamber to the baffle housing of the
fuel delivery unit -1- on the
right.
...
© 2016-2024 Copyright www.vwgolf.org