Assist systems menuConicity
Conicity is caused by a slight offset of the tread and/or
the belt (amounting to a few tenths of a millimetre) relative to
the geometric centre of the tyre. Taper is not visible and
cannot be measured with equipment available in the workshop.
& ...
Safety precautions when using test and measuring equipment during a road
test
Observe the following if test and measuring equipment is
required during a road test:
WARNING
Accident hazard as a result of distraction and
inadequate securing of test and measuring equipment. ...
Assembly overview - interior monitoring, LHD vehicles
1 -
Anti-theft alarm system sensor -G578-
Removing and installing
→ Chapter
Needs parameterisation after renewal
→ Chapter
2 -
Bolt
Qty. 4
Specified ...