First read and observe the introductory information and safety warnings
Lit up | Possible cause | Solution |
---|---|---|
Engine management system fault (Electronic Power Control). | The engine should be checked by a qualified workshop as soon as possible. | |
Diesel engine is preheating before starting. | . | |
Fault in catalytic converter. | Decrease speed. Drive carefully to the next qualified workshop. The engine should be checked. | |
Diesel particulate filter has become saturated with soot. | Drive for approximately 15 minutes in 4th gear (manual
gearbox) or select D (automatic gearbox) at a speed of
at least 70 km/h (45 mph). Please observe any applicable speed limits . If the indicator lamp still does not go out, proceed to a qualified workshop. |
Flashes | Possible cause | Solution |
---|---|---|
Fault in engine management system (diesel engine). | The engine should be checked by a qualified workshop as soon as possible. | |
Misfiring, which damages the catalytic converter. | Decrease speed. Drive carefully to the next qualified workshop. The engine should be checked. |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
WARNING
Please observe legal requirements if cleaning the diesel particulate filter when in traffic.NOTICE
To avoid damage to your vehicle, always observe the indicator lamps and associated warning texts.If the indicator lamps , or are lit up, fuel consumption may be higher and engine performance reduced.
Removing and fitting head restraints
Fig. 48 Removing the front head restraint
Fig. 49 Removing the rear head restraint
First read and observe the introductory information
and safety warnings Every seat is fitted with a head restraint. The front
head restraints are intended solely for use with the front seats, and the centr ...
Removing and installing auxiliary air heater element - Z35- with auxiliary
air heater control unit - J604-, RHD vehicles
Removing
–
Remove centre console
→ General body repairs, interior; Rep. gr.68.
–
Remove glove compartment
→ General body repairs, interior; Rep. gr.68.
...
Removing and installing control unit and hydraulic unit, RHD vehicles
Special tools and workshop equipment required
Torque wrench -V.A.G 1331-
Torque wrench -V.A.G 1410-
Brake pedal depressor -V.A.G 1869/2-
Sealing plugs, assemb ...